Quick start
For 8'-1 1/16", tap 8 Feet 1 Inch 1 / 1 6. Add, subtract, multiply or divide measurements just like plain numbers.
Tap again for more
- Width: area, diagonal, perimeter
- Height: volume, walls, whole room
- Circle and Arc: related sizes
For 8'-1 1/16", tap 8 Feet 1 Inch 1 / 1 6. Add, subtract, multiply or divide measurements just like plain numbers.
Choose the smallest fraction shown for inch results.
Type measurements the way you'd say them out loud. The unit keys are part of the number, so the calculator always knows whether you're working with a length, an area or a volume.
Go from the biggest unit to the smallest. For 8 feet 1 and 1/16 inches, tap 8 Feet 1 Inch 1 / 1 6. The / key starts a fraction; it is not division (use ÷ for that). Always tap / between the top and bottom numbers; the calculator won't guess where a fraction splits. Mixed units work too: 3 m 25 cm or 2 Yards 1 Feet 6 Inch. A fraction with no number in front takes the unit you press next, so 3 / 4 Feet is 9 inches. Answers round to the fraction size you pick in settings (⚙) and show as a stacked fraction.
2nd unlocks the second job of the next key you press. 2nd + a unit shows the current value in that unit. 2nd + Feet switches between feet-and-inches and decimal feet. 2nd + 2, 4, 8, 1, 3 or 6 sets fraction size to 1/2, 1/4, 1/8, 1/16, 1/32 or 1/64 inch. 2nd + Arc enters a radius, and 2nd + M+ subtracts from memory.
Enter a length and tap Length, then a width and tap Width. Keep tapping Width to step through area, diagonal and perimeter. Add a height with Height, then keep tapping it for volume, wall area and total room area (walls plus ceiling).
Tap a unit key again to square it and a third time to cube it: 100 Feet Feet is 100 square feet. Multiplying two lengths gives an area; multiplying by a third gives a volume.
Enter a diameter and tap Circle, then keep tapping for area and circumference. With a diameter set, enter an arc length (or an angle in degrees) and tap Arc. Keep tapping for the matching angle or length, chord, segment area, sector area and rise.
For waste allowance, add a percent: 2.78 Yards Yards Yards + 10 %. For lumber, 2 × 4 × 16 Board Ft gives 10.6667 board feet.
Tap Clear once to clear the display and twice to also reset saved room and circle values. Off blanks the screen. Neither one touches memory (M+) or the Save slot; tap 2nd + Clear to empty those.